Samsung SGH-E100 Service Manual page 9

has 16 bit data line, HD[0~15] which is connected to OM6357. It has 23 bit address lines,
HA[1~23]. NCSFLASH_NAND and NCSRAM signals is chip select.
Writing process, HWR_N is low and it enables writing process to flash memory and SRAM.
During reading process, HRD_N is low and it enables reading process to flash memory and
SRAM. Each chip select signals in the OM6357 select memory among 2 flash memory and
UtRAM.
Reading or writing procedure is processed after HWR_N or HRD_N is enabled. Memories use
reset, which is VDD3 delay from PCF50601. HA[22] signal enables lower byte of SRAM and
HA[22] signal enables higher byte of SRAM.
10. OM6357
OM6357 is consisted of ARM core and DSP core. It has 8x1Kword on-chip program/data RAM,
55 Kwords on-chip program ROM in the DSP. It has 4K*32bits ROM and 2K*32bits RAM in the
ARM core. DSP is consisted of KBS, JTAG, EMI and UART. ARM core is consisted of EMI,
PIC(Programmable Interrupt Controller), reset/power/clock unit, DMA controller, TIC(Test Interface
Controller), eripheral bridge, PPI, SSI(Synchronous Serial Interface), ACC(Asynchronous
communications controllers), timer, ADC, RTC(Real-Time Clock) and keyboard interface.
KBIO(0:7), address lines of DSP core and HD[0~15]. HA[1~23], address lines of ARM core and
HD[0~15], data lines of ARM core are connected to memory.
NCSRAM, NCSFLASH_NAND in the ARM core are connected to each memory. HWR_N and
HRD_N control the process of memory. External IRQ(Interrupt Request) signals from each units,
such as, PMU need the compatible process.
KBIO[0~7] receive the status from key and RXD0/TXD0/IrDA_DOWN are used for the
communications using IRDA and data link cable(DEBUG_DTR/RTS/TXD/RXD/CTS/DSR).
It has JTAG control pins(TDI/TDO/TCK) for ARM core and DSP core. It receives 13MHz clock
in CKI pin from external TCXO. ADC(Analog to Digital Convertor) part receives the status of
temperature, battery type and battery voltage.
11. TCO-9141G(26MHz)
This system uses the 26MHz TCXO, TCO-9141G, Toyocom. AFC control signal from OM6357
controls frequency from 26MHz X-tal. The clock output frequency of UAA3536HN is 13MHz.
This clock is connected to OM6357, YMU762.
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2-5
SGH-E100 Circuit Description