Samsung SGH-X430 Service Manual page 6

2. SGH-X430 Circuit Description
5. Si 4205 (U100)
This chip integrates three differential-input LNAs.
The GSM input supports the E-GSM, DCS input supports the DCS1800, PCS
input supports the PCS1900. The LNA inputs are matched to the 200 ohm
differential output SAW filters through eternal LC matching network.
Image-reject mixer downconverts the RF signal to a 100 KHz intermediate
frequency(IF) with the RFLO from SI4133T frequency synthesizer.
The RFLO frequency is between 1737.8 ~ 1989.9 MHz.
The Mixer output is amplified with an analog programmable gain
amplifier(PGA), which is controlled by AGAIN.
The quadrature IF signal is digitized with high resolution A/D converts (ADC).
The SI4205 down-converts the ADC output to baseband with a digital
100 KHz quadrature LO signal.
Digital decimation and IIR filters perform channel selection to remove blocking
and reference interface signals. After channel selection, the digital output is
scaled with a digital PGA, which is controlled with the DGAIN. DACs drive a
differential analog signal onto the RXIP, RXIN, RXQP, RXQN pins to interface
to standard analog-input baseband IC.
2) TX PART
Baseband IQ signal fed into offset PLL, this function is included inside
of U100 chip.
SI4205 chip generates modulator signal which power level is about 1.5dBm
and fed into Power Amplifier(U200).
The PA output power and power ramping are well controlled by Auto
Power Control circuit. We use offset PLL below,
Modulation
Spectrum
This Document can not be used without Samsung's authorization
200kHz offset
30 kHz bandwidth
400kHz offset
30 kHz bandwidth
600kHz ~ 1.8MHz offset
30 kHz bandwidth
SAMSUNG Proprietary-Contents may change without notice
GSM
DCS
PCS
GSM
DCS
PCS
GSM
DCS
PCS
2-2
-35dBc
-35dBc
-35dBc
-66dBc
-65dBc
-66dBc
-75dBc
-68dBc
-75dBc