Configuring Port Rate Limit - Supermicro SSE-X3348S Configuration Manual

1.6.5 Configuring Port Rate Limit

Rate limit is disabled by default in Supermicro switches. Follow the below steps to enable the port rate
limit.
Step Command
Step 1 configure terminal
interface <interface-type><interface-id>
Step 2
or
interface range <interface-type><interface-id> ....
Step 3 rate-limit
10000000)><burst-value-kbits (1-10000000)>
Step 4 End
show interface [{ [<interface-type><interface-id>]
Step 5
rate-limit
output <rate-value-kbps
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode
(Optional) Enters
configuration mode.
interface-type – may be any of the
following:
gigabit-ethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the "interface range ..." command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers. E.g.: int range gi 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range gi 0/1-10, gi 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
(1- Enables the egress rate limit for the
interface(s), set to the closest rate
(kbps) and burst size (kbits) as the
hardware capabilities. Rate limiting is
applied to packets sent out on a
particular interface.
Rate limit and burst size in range of1-
10000000.
Exits the configuration mode.
Displays the rate limit configuration on
an interface
the interface
24