Assembly And Use For The Single Serve Cup - Ninja Single Serve System Pulse BL100 Owner's Manual

Assembly and Use for the Single Serve Cup

ASSEMBLY
Fig. 1
Fig. 2
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface such
as a counter or table top.
2 Add ingredients to the single serve cup.
3 Place the single serve blade onto the cup and screw it
tightly until you have a good seal. (Fig. 1)
4
Turn the single serve cup upside down and place it onto
the motor base, aligning the tabs on the cup with the
motor base. Turn to the left, the unit is ready for use.
(Fig. 2)
5 Press down on the top of the cup in short intervals to
activate. (Fig. 3)
PULSE
Fig. 3
For best results, use short "PULSES"... Practice makes perfect!!
REMOVAL
Fig. 4
6 When you have reached your desired consistency, stop
the appliance by removing your hand from the single
serve cup. Then turn the single serve cup to the right
(Fig. 4) and pull straight up to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling, do not add
ingredients past the "Max" fill line.
7 Turn the cup upright and remove the single serve
blade by twisting the blade assembly to the left.
8 Place the To-Go drinking lid onto the single serve
drink cup, twist to seal and enjoy!
9
Make sure that the motor base is unplugged when not
in use.
www.ninjakitchen.com
Fig. 5
9