Specifications; Unpacking - Ryobi ZRRY41002 Series Operator's Manual

MOTOR
Motor Type ......................................................................................................................................................... 120 V AC
Operating RPM.......................................................................................................................................................... 7500
Amperes ................................................................................................................................................................ 6 amps
DRIVE SHAFT AND CUTTING HEAD
Drive Shaft.............................................................................................................................................. 1/4 in. Flex Shaft
Cutting Head ...................................................................................................................................... Bump Line Release
Cutting Path Diameter...............................................................................................................................15 in. (381 mm)
Drive Shaft Housing ..................................................................................................................................Aluminum Tube
Cutting Line Diameter .................................................................................................................................080 in. (2 mm)
INSTRUCTIONS
Carefully remove the parts from the box.
n
n Inspect the parts carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
n
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call
n
1-800-860-4050 for assistance.
WARNING:
If any parts are missing, replace them before opera-
ing the product. Failure to do so could result in seri-
ous personal injury.

SPECIFICATIONS

UNPACKING

PACKING LIST
Upper shaft (Power head) (1)
Attachment shaft (Cutting head) (1)
Front Handle (1)
Carriage bolt - 6 mm x 50.0 mm (1)
Flat washer - 6 mm (1)
Wing nut - 6 mm (1)
Grass deflector (1)
Wing nut - 1/4 in. (1)
Flat washer - 1/4 in. (1)
Lock washer - 1/4 in. (1)
Hex bolt - 1/4 in. x 2 in. (1)
Operator's manual
Page 7