Maintenance - Ryobi RY30120 Operator's Manual

DEBRIS FLAP REPLACEMENT
See Figure 25.
Replace the debris flap if it is worn.
 Using a 10 mm wrench or socket, remove the retaining
nuts, washers, and debris flap.
 Install the new debris flap. This replacement part is avail-
able from the place of purchase, or by calling 1-800-242-
4672.
 Replace retaining nuts and washers.
 Tighten securely.
STORAGE (1 MONTH OR LONGER)
 Drain all fuel from tank into a container approved for
gasoline. Run engine until it stops.
 Abide by all ISO and local regulations for the safe storage
and handling of gasoline. Excess fuel should be used up
in other 2-cycle engine powered equipment.
 Clean all foreign material from attachments. Do not grasp
exposed cutting blades when picking up or holding the
attachments.
 Store idle unit indoors in a dry, well-ventilated area that
is inaccessible to children. Keep away from corrosive
agents such as garden chemicals and de-icing salts.
ATTACHING THE STORAGE HANGER
See Figure 26.
There are two ways to hang the attachment for storage.
 To use the hanger cap, push in the button and place the
hanger cap over end of the lower end of attachment shaft.
Slightly rotate the cap from side to side until the button
locks into place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.

MAINTENANCE

RETAINING NUTS
WASHERS
DEBRIS FLAP
SECONDARY
BUTTON
19
HOLE
HOLE
EDGER GUARD
Fig. 25
HANGER
CAP
Fig. 26