Starting And Stopping - Ryobi RY30120 Operator's Manual

STARTING AND STOPPING

See Figures 5 - 7.
TO START A COLD ENGINE:
DO NOT squeeze the throttle trigger until the engine starts
and runs.
 Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the rope until the engine starts.
 Wait 6-10 seconds, then squeeze the trigger to run.
NOTE: Squeezing the throttle trigger releases the start lever
to the RUN position.
TO START A WARM ENGINE:
PULL the rope until the engine starts.
TO STOP THE ENGINE:
Press and hold the switch in the stop "
the engine stops.
THROTTLE
TRIGGER
OPERATION
" position until
IGNITION
SWITCH
TRIGGER
LOCK
Fig. 5
11
IGNITION
SWITCH
THROTTLE TRIGGER
START POSITION
START LEVER
RUN POSITION
START LEVER
PRIMER BULB
TRIGGER LOCK
Fig. 6
Fig. 7