Assembly - Ryobi RY46501B Operator's Manual

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Cultivator
Drag Bar
Pull Pin
Hitch Pins (2)
Felt Washers (2)
Inner Tines (2)
Outer Tines (2)
Wheel Assembly (Accessory)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Failure to heed this warn-
ing could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.

ASSEMBLY

WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
POSITIONING THE HANDLEBAR
See Figure 2.
 Loosen the two handlebar knobs.
 Unfold the handlebar into operating position.
NOTE: Do not use force. If there is binding, continue
to loosen the knobs. Do not allow the switch cable to
become pinched when raising the handlebar.
 Retighten the handlebar knobs.
HANDLEBAR
9
HANDLEBAR
KNOBS
SWITCH
CABLE
Fig. 2