Assembly Instructions; Installing And Adjusting D-Handle - Ryobi 700r Operator's Manual

INSTALLING AND ADJUSTING THE
D-HANDLE
1. Push the D-handle down onto the shaft
housing so that the handle slants to the
powerhead (Fig. 1). The squared bolt hole in
the handle is to the right.
Bolt
2. Insert the shoulder bolt into the squared hole
in the handle. Place the washer on the bolt,
and screw the wing nut onto the bolt.
3. Rotate the D-handle to place the grip above
the top of the shaft housing.
4. While holding the unit in the operating
position (Fig. 2), position the D-handle to the
location that provides you the best grip.

ASSEMBLY INSTRUCTIONS

Wing
Nut
Washer
Fig. 1
Fig. 2
5. Tighten the wing nut (Fig. 3).
Grip
Fig. 3
9