Advertisement
After Treatment
Cleaning
Clean the device after each use.
●Turn the power OFF when cleaning the device.
Cleaning without turning off the power may cause an electrical
shock hazard, short circuit, or fire hazard.
WARNING
1
Make sure the power is turned off.
2
After use in the shower or bath, shake the device up and down to
remove any excess water on the unit.
3
Wipe the surface of the device with a dry towel.
* Make sure no water remains inside the rollers or around the
charging terminal.
* Do not use any detergents or solvents.
* Wipe off with dry towel or tissue any lubricant that oozes from the
base of the rollers.
4
Dry thoroughly and store in a well-ventilated place.
* Never leave the device wet as this may cause damage, malfunction,
or leave an unusual odor.
Storing
Always remove excess water and dry thoroughly after each use before storing.
●
Leaving the device wet may cause a malfunction or corrosion.
If you will not be using the device for an extended period, clean the device before
●
storing.
When not in use, turn off the power, unplug the AC adapter from the wall socket,
●
remove any moisture from the device and dry well before storing.
Do not leave the device near fire or flame, under direct sunlight, or in humid
●
places such as the bathroom. Store only in a clean, well-ventilated place.
Keep this device out of the reach of children or pets.
●
Maintenance and Inspection
If you have not used the device for an extended period, inspect it carefully and
●
check that the device works properly and safely.
If there is any evidence of a malfunction, refer to the "Troubleshooting" section
●
(p.22) before calling for service.
If the device malfunctions, appears damaged, or needs service, please contact
●
your local distributor.
21
Troubleshooting
Checklist
If you encounter anything abnormal during use, check below.
Symptom
Possible Cause
You have not
pressed the Power
→
Power does not
button to turn on
turn on
Battery not charged
→
Battery Power Lamp
→
is flashing
Battery is not
sufficiently charged
→
Device only
operates for a few
minutes even after
Battery life is ended
→
charging
AC Adapter or USB
cable is not properly
→
connected
Unit does not start
charging (EMS
Mode / Level lamps
Main unit is not
→
do not flash red)
firmly set onto the
charging stand
You are pressing the
Power turns off
Power/Mode button
→
for over 3 seconds
Solution
Press and hold
Power / Mode to turn
→
on the power
→
Fully charge the
battery (p.11)
→
Contact your local
distributor.
* Do not attempt to
→
replace the battery
yourself as this may
cause a malfunction
Connect AC Adapter
or USB cable to main
→
unit correctly (p.11)
Place main unit on
charger stand and
→
push down until the
Mode / Level lamps
are red (p.11)
22
Advertisement
