Operation - Ryobi A25RT02 Operator's Manual

INSERTING/REMOVING CUTTERS
 Unplug the router table and/or the router.
 Remove the router/insert plate assembly. (See Installing
Router/Insert Plate Assembly in the Assembly section.)
WARNING:
If you are changing a cutter immediately after use, be
careful not to touch the cutter or collet with your hands or
fingers. They will get burned because of the heat buildup
from cutting. Always use a wrench.
 Consult the router operator's manual for proper cutter
removal/installation procedure and replace cutter.
ADJUSTING DEPTH OF CUT
We recommend that cuts be made at a depth not exceeding
1/8 in. and that several passes be made to reach depths of
cut greater than 1/8 in.
ADJUSTING THE MITER GAUGE
See Figure 21.
 Unplug the router table and/or the router.
 Loosen the miter gauge knob.
 Rotate the miter gauge to the desired angle.
 Tighten the miter gauge knob.
POSITIONING THE FENCE
See Figure 22.
The fence enables you to support and guide the work-
piece.
 Unplug the router table and/or the router.
 Loosen the fence lock knobs.
 Position the fence to the desired location.
 Tighten the fence lock knobs.
NOTE: The outfeed fence has joining capabilities and can
be adjusted out in increments up to 1/4 in. and enable
you to support the workpiece as it exits the cutter.
WARNING:
When making a side or edge cut, never position the fence
such that the workpiece is located between the cutter
and the fence. Failure to heed this warning can result in
serious personal injury.

OPERATION

FENCE LOCK KNOBS
CUTTER
18
MITER
GAUGE KNOB
MITER GAUGE
OUTFEED FENCE
LOOSEN
1/4
0
TIGHTEN
SCALE
PROPER
DISTANCE
Fig. 21
SCALE
Fig. 22