LG SB94PK-S Owner's Manual page 20

HB994PK-F.AIRNDLK_ENG_9793
4.
If you have security on your access point or wireless router, verify that the
WEP or WPA key that was entered into the player matches the router's
information exactly. You need to input the security code as necessary.
Notes:
• WEP security mode generally have 4 keys available on an access point
or wireless router's setting. If your access point or wireless router use
WEP security, enter the security code of the key "No.1" to connect on
your home network.
• An Access Point is a device that allows you to connect to your home
network wirelessly.
[Push Button] – If your access point or wireless router that
supports Push Button Configuration method, select this option and press
the Push Button on your access point or wireless router within 120
counts. You do not need to know the access point name (SSID) and
security code of your access point or wireless router.
[Manual] – Your access point may not be broadcasting its access point
name(SSID). Check your router settings through your computer and
either set your router to broadcast SSID, or manually enter the access
point name(SSID) in [Manual].
20
7/14/10 7:44 PM Page 20
The player scans the all available
access points or wireless routers
within range and display them as
a list. Use U/u to select an
access point or wireless router on
the list, and then press ENTER.
5.
Use U/u/I/i to select the IP mode between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP address automatically.
Note:
If there is no DHCP server on the network and you want to set the IP
address manually, select [Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using U/u/I/i and numerical buttons.
If you make a mistake while entering a number, press CLEAR to clear the
highlighted part.
6.
Select [OK] and press ENTER to apply network settings.
7.
The player will ask you to test the network connection. Select [OK]
and press ENTER to complete the network connection.
8.
If you select [Test] and press ENTER at step 7 above, the network
connection status is displayed on the screen.
You can also test it on the [Connection Status] in the [Setup] menu.