Adjustments - Ryobi AG452 Operator's Manual

WARNING:
Before performing any adjustment, make sure the tool
is unplugged from the power supply and the switch is in
the OFF ( O ) position. Failure to heed this warning could
result in serious personal injury.
GUARD ADJUSTMENT
See Figure 9 - 11.
Never use the angle grinder without the guard in place and
properly adjusted.
 Unplug the angle grinder.
 Using the wrench provided, loosen and remove nut,
accessory wheel, and disc flange from spindle if neces-
sary.
 Unlock the guard clamp lever.
 Rotate the guard to its correct position as shown in figures
9 and 10.
 Lock the guard clamp lever.
 Retighten clamp screw securely if needed.
WARNING:
Never place the guard so that it is on front of the angle
grinder as shown in figure 11. This could result in serious
injury because sparks and loose particles thrown from the
grinding wheel would be directed toward the operator.
Always place the guard in the correct location as shown
in figures 9 and 10.
DANGER:
Never use your grinder with the guard removed. It has
been designed for use only with the guard installed.
Attempting to use grinder with guard removed will result
in loose particles being thrown against the operator
resulting in serious personal injury.

ADJUSTMENTS

LOCATION OF GUARD IS
BETWEEN POINTS
LOCATION OF GUARD
13
A
CORRECT
A AND B
B
INCORRECT
Fig. 9
Fig. 10
Fig. 11