Setting Up The Quick; Clear All Data - Cateye CC-RS100W Quick Start Up Manual

Setting up the QUICK

When using the
QUICK for the
first time, con-
figure the initial
settings.
1

Clear all data.

Press the AC button on the back of the QUICK.
* All data is deleted and the QUICK is reset to its
factory default settings.
2
Select the measurement unit.
Select "km/h" or "mph".
3
Set tire circumference.
Enter the tire circumference of the front
wheel in mm. (100 – 3999 mm)
* Refer to "Tire circumference" (page
4
Set the clock.
Each time MODE is pressed and held,
settings switch from time display mode,
to hours, to minutes.
5
Press MENU to complete setup.
Setup is completed and the QUICK switches to the measure-
ment screen.
For instructions on how to start measurement, refer to
"Starting measurement" (page
MODE
Battery
case cover
MENU
AC
6).
Time display mode
Hours Minutes
7).
5
MODE
Short press
MODE
Long press
(2 sec.)
AC
MODE
km/h ↔ mph
MENU
( Back side )
Confirm
MODE
Increase numbers
MODE
Move to next digit
(Press and hold)
MENU
( Back side )
Confirm
MODE
Switch between 24h and
12h or increase numbers
MODE
Switch setting item or
move to next digit
(Press and hold)
MENU
( Back side )
Setup complete
1
2
( 1/2 )
3
4