To Unfold Stroller; To Attach An Infant Car Seat - Baby Trend SNAP N GO 1305 Instruction Manual

TO UNFOLD STROLLER:

Do Not allow children near stroller while unfolding.
• Release the folding latch, which is located on the right side. See
fi gure 8.
• Lift up on the stroller handle with both hands until the stroller frame
is erect and locked in the open position. See fi gure 9. The stroller
has spring-loaded latches on both sides of the frame. Test that both
latches are fully engaged prior to placing your child in the stroller.

TO ATTACH AN INFANT CAR SEAT

• Place car seat onto front bar. See fi gure 10. NOTE: Some brands
of infant car seats will lock onto the front bar, and some brands
may simply rest on the front bar, You must ALWAYS use the
safety belt to secure every car seat that is placed on the snap n
go.
• Make sure the front of the car seat rests on the red support tabs located
on the frame. See fi gure 11. NOTE: For wider car seats there is a
higher support tab located above the main red support tabs.
• Strap the safety belt over the carseat and connect the buckles together.
Tighten the strap so the car seat fi ts snug and can't move. See fi gure
12. NOTE: Some car seats have slots for the safety belt to slide
through, if you have a car seat with these slots please feed the
safety belt through each slot and secure. See fi gure 13
WARNING:
from falling, ALWAYS use the safety belt
to secure carseat to stroller.
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363
BETWEEN THE HOURS OF 8:00AM AND 4:30PM PACIFIC COAST TIME FOR ASSISTANCE.
Avoid serious injury
Figure 13.
Figure 9.
Figure 10.
FRONT
SUPPORT
TAB
Figure 11.
Figure 12.
4