Humminbird HELIX 7 Series Installation Manual page 4

HELIX® 7 Series In-Dash Mounting Installation Guide
5. Route and Connect the Cables
1. See the installation guides included with each hardware
component to install power and other optional equipment.
2. Route all cables (power, transducer, accessories) to the control
head and insert the connectors into the correct ports on the back
of the control head (see the illustration Connecting the Cables).
CAUTION! Do NOT mount the cables where the connectors could
be submerged in water or flooded. If cables are installed in a splash-
prone area, it may be helpful to apply dielectric grease to the inside
of the connectors to prevent corrosion. Dielectric grease can be
purchased separately from a general hardware or automotive store.
Connecting the Cables
Your control head is ready for on-the-water operation. See your control
head operations manual for further details.
Contact Humminbird
Web site
E-mail
Telephone
Direct Shipping
WARNING! This device should not be used as a navigational aid to
prevent collision, grounding, boat damage, or personal injury. When the boat
is moving, water depth may change too quickly to allow time for you to react.
Always operate the boat at very slow speeds if you suspect shallow water or
submerged objects.
WARNING! Disassembly and repair of this electronic unit should only be
performed by authorized service personnel. Any modification of the serial
number or attempt to repair the original equipment or accessories by
unauthorized individuals will void the warranty.
humminbird.com
service@humminbird.com
1-800-633-1468
Humminbird
Service Department
678 Humminbird Lane
Eufaula, AL 36027 USA
FCC NOTICE: This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION! This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention
of Johnson Outdoors Marine Electronics, Inc. to be a responsible corporate citizen,
operating in compliance with known and applicable environmental regulations, and
a good neighbor in the communities where we make or sell our products.
WEEE DIRECTIVE: EU Directive 2002/96/EC "Waste of Electrical and Electronic
Equipment Directive (WEEE)" impacts most distributors, sellers, and manufacturers of
consumer electronics in the European Union. The WEEE Directive requires the
producer of consumer electronics to take responsibility for the management of waste
from their products to achieve environmentally responsible disposal during the product
life cycle.
WEEE compliance may not be required in your location for electrical & electronic
equipment (EEE), nor may it be required for EEE designed and intended as fixed or
temporary installation in transportation vehicles such as automobiles, aircraft, and
boats. In some European Union member states, these vehicles are considered outside
of the scope of the Directive, and EEE for those applications can be considered
excluded from the WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must
not be disposed of with other household refuse. It must be disposed of
and collected for recycling and recovery of waste EEE. Johnson Outdoors
Marine Electronics, Inc. will mark all EEE products in accordance with the
WEEE Directive. It is our goal to comply in the collection, treatment, recovery, and
environmentally sound disposal of those products; however, these requirements do
vary within European Union member states. For more information about where
you should dispose of your waste equipment for recycling and recovery and/or
your European Union member state requirements, please contact your dealer or
distributor from which your product was purchased.
HELIX® and Humminbird® are registered trademarks of Johnson Outdoors
Marine Electronics, Inc.
© 2017 Johnson Outdoors Marine Electronics, Inc. All rights reserved.
4
532365-2_A