Baby Einstein 30886 Instruction Manual page 5

Operating Instructions
Using the Seat Restraint
1 To secure the baby in the bouncer seat...
A Open the buckles on both
sides of the restraint by
squeezing the latches
together and pulling each
buckle apart.
B Position the fabric restraint
toward the front edge of the
seat pad.
C Place the infant in the seat. The seat restraint should be
visible between the baby's legs.
D Lift the seat restraint up
and toward the baby's
waist.
E Buckle the straps on each
side of the frame. Squeeze
each buckle together until
it audibly clicks as it
latches.
2 Adjust and check the straps.
A Adjust the straps in the buckles as needed so that the
restraint fits snugly (but not too tightly).
B Be sure the seat restraint is secure by pulling it away
from the baby's body. The buckles should remain
fastened.
Using the Vibration Function
Vibration calms and soothes the baby.
Vibration ON/OFF switch – This switch is on
the front of the vibration unit. Slide it to the
ON or OFF position.
Vibration ON/OFF
Switch
OFF ON
– 5 –
Using the Toy Bar Functions
The toy bar has lights and melodies to entertain the baby.
The lighted characters dance in rhythm to the music. The
characters include:
• Octopus
™
• Baby Monet (zebra)
• Cardinal
™
• Baby Shakespeare (gecko)
Toy Bar Power Switch – This switch is on the
vibration unit. The vibration unit provides power
to the toy bar.
The switches that control toy bar functions are on the head of
the caterpillar.
Volume Control
Toy Bar Mode Switch – Use this switch to
select between Interactive Mode and Play
Mode (described below).
Motion Mode – For motion-activated play.
Movement of the bouncer causes the toy bar to
play a randomly selected melody. The Song List
is on page 6. Dancing lights on the toy bar pulse
in rhythm to the music.
After the melody ends, the next movement of the bouncer
will play a new, randomly selected melody. However, if
2 minutes pass without movement of the bouncer, the unit
performs an auto-shutoff. To enable the toy bar functions,
turn the Toy Bar Power Switch OFF and then ON again.
Play Mode – For continuous play with auto-
shutoff after 15 minutes. The toy bar plays all the
songs in the song list (see page 6).
After 15 minutes of music and the completion of
the last melody, the unit performs an auto-shutoff. To enable
the toy bar functions, turn the Toy Bar Power Switch OFF
and then ON again.
Volume Control Switch – Slide the switch to
the left or right to select low or high music
volume settings.
Toy Bar Power Switch
OFF ON
Toy Bar
Switch Mode Switch