Baby Einstein 30886 Instruction Manual

30886
lights and melodies
bouncer
Instruction Guide
Congratulations on your purchase of a new Baby Einstein
product! Please read all instructions before assembly and use
of the bouncer.
WARNING
Safety Guidelines to Prevent Injury
• NOT INTENDED FOR CARRYING BABY.
• NEVER leave child unattended in the bouncer.
• ALWAYS use restraint system.
• NEVER use for a child who is able to sit upright
unassisted.
• NEVER place a child over 25 lbs. (11 kg) in the
bouncer.
• NEVER lift bouncer using the toy bar as a handle.
• NEVER move unit while child is in seat!
• NOT for use in automobile or airline travel.
• NEVER use as a car seat or infant carrier.
• NEVER attach any additional strings or straps to
product or toy bar.
FALL HAZARD:
• A child's movement can slide the
bouncer.
• NEVER place the bouncer on
countertops, tables, on or near steps
or on other elevated surfaces.
• ALWAYS use on the floor.
ESPAÑOL: PÁGINA 7 • FRANÇAISE : PAGE 13
IMPORTANT! KEEP FOR FUTURE REFERENCE.
SUFFOCATION HAZARD:
• NEVER use on a soft surface (bed, sofa, cushion),
as seat may tip over and cause suffocation.
IMPORTANT:
• Adult assembly required.
• Care should be taken when unpacking the bouncer.
• Examine product frequently for damaged, missing,
or loose parts.
• Do not use product if damaged or broken.
Assembly Instructions
1 Connect the wire uprights to the base frame
wire.
A Place the base frame wire on a flat surface. The two rear
anti-skid feet must be facing down, contacting the
surface.
™
Left wire upright
B Locate the left and right wire uprights and place them
near the corresponding ends of the base frame wire. If the
parts are correctly placed, the holes in the sockets will be
on top.
C Push the socket on
the end of the left
wire upright onto
the left end of the
base frame wire.
The hole in the
side of the socket
must face inward
toward the
opposite end of
the base frame
wire.
D Press the spring-loaded button and push the socket until
the spring-loaded button fully engages, locking the frame
wires together.
E Repeat Steps C and D for the right wire upright.
– 1 –
Base frame wire
Anti-skid feet
Holes
on top
Right wire
upright
Hole in side of
socket