Measurement And Adjusting The Final Gear Lash - Yamaha YFM45FAT Supplementary Service Manual

REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
1
2
1
a
GEAR AND DRIVE SHAFT
Shims are supplied in the following thick-
nesses.
Thickness (mm)
L LLL L LLL L
MEASUREMENT AND ADJUSTING THE
FINAL GEAR LASH
Final gear lash measurement
1. Remove:
• drain plug
• gasket
2. Install:
• a bolt of the specified size 1
(into the drain plug hole)
CAUTION:
Finger tighten the bolt until it holds the ring
gear. Otherwise, the ring gear will be dam-
aged.
3. Attach:
• gear lash measurement tool 1
• dial gauge 2
a Measuring point is 34.15 mm (1.34 in)
– 44 –
DRIV
Final drive pinion gear shim
0.15
0.45
L LLL L L LLL L L LLL L
Gear lash measurement tool
P/N. YM-01467, 90890-01467
0.30 0.40
0.50
L LLL L LLL