Remote Control Description - Runco Reflection VX-1000d Owner's Operating Manual

Remote Control Description

(1) ON/OFF
Switches Power ON/OFF. (This does not operate when POWER/STANDBY indicator of
the main unit is off.)
(2) IR OUTPUT INDICATOR
Illuminates when a button in pressed, indicating that an IR signal is being transmitted.
(3) ENTER BUTTON
When an item is highlighted on a menu, pressing ENTER will select that item.
(4) CURSOR ( / /
Use these buttons to select items or settings and to adjust settings or switch the display
patterns.
UP Button: When no menus are present on-screen, the UP button will toggle through
aspect ratios in the following order: (RATIO)
Anamorphic Standard (4:3)
LEFT Button: When no menus are present on-screen, the LEFT button will toggle
through the different sources in the following order: (INPUT)
HD Pass Thru 2 HD Pass Thru1
Component SD S-Video 2
DOWN Button: When no menus are present on-screen, the RIGHT button will toggle
through the different sources in the following order: (RATIO)
VirtualWide Letterbox
RIGHT Button: When no menus are present on-screen, the RIGHT button will toggle
through the different sources in the following order: (INPUT)
Composite S-Video 1
DVI 1 DVI 2 HD Pass Thru 1
(5) LIGHT BUTTON
Press this to illuminate the buttons.
(6) MENU BUTTON
Pressing this button will access the OSD controls. Press this button during the display of the sub-menu to return to the
previous menu.
(7) VIDEO BUTTON
Press this button to select VIDEO (composite video) as the source.
(8) COMP BUTTON
Press this button to select Component SD (480i/576i) input.
(9) DIRECT ACCESS BUTTONS
These red buttons to the right hand-side will allow you direct access to an aspect ratio, or selection of a number in
certain cases. These buttons are:
ANA - selects Anamorphic aspect ratio
4x3 - selects Standard 4:3 aspect ratio
(10) S-VID 1 and S-VID 2 BUTTONS
Press this button to select between S-Video 1 and S-Video 2 inputs.
(11) HD1 and HD2 BUTTONS
Press this button to select between HD1 (High Definition) signal and HD2 signal inputs. Auto detect component input,
YPbPr or RGBHV.
(12) DVI 1 and DVI 2 BUTTONS
Press this button to select between DVI1 signal and DVI2 signal input.
/ )
Letterbox
DVI 2 DVI 1
S-Video 1 Composite
Standard (4:3)
S-Video 2 Component SD
HD Pass Thru 2
VirtualWide
HD/RGB2 HD/RGB 1
Anamorphic
HD/RGB 1 HD/RGB 2
LETBOX - selects Letterbox aspect ratio
V-WIDE - selects VirtualWide aspect ratio
13
1 2
4
5
7
10
11
12
3
6
8
9