Advertisement
ASRock Utility Control Switch
SW1
Utility control
On
Disabled
Off
Enabled
SW2
SW3
CARD number
Off
Off
CARD 1
On
Off
CARD 2
Off
On
CARD 3
On
On
CARD 4
SW4: no function
Card Fan Switch
Use this switch to control the card fan speed.
Off: Full (The fan runs at full speed)
ON: Half (The fan runs at half speed, with a half voltage supply)
Graphics 12V Power Connector
This card provides a 6-pin graphics 12V power connector. Install the PSU's
power cable to this connector when more than two M.2 cards* are installed.
*Intel Optane SSD 900P or other M.2 card with higher power consumption
Installing M.2 SSD Module
1. Depending on the PCB type and length of your M.2_SSD (NGFF) module,
find the corresponding nut location to be used.
4
3
2
1
No.
1
Nut Location
A
PCB Length
4.2cm
Module Type
Type 2242
2. Move the standoff based on the module type and length. The standoff is
placed at the nut location C by default. Skip Step 3 and 4 and go straight to
Step 5 if you are going to use the default nut. Otherwise, release the standoff
by hand.
A
3. Peel off the yellow protective film on the nut to be used. Hand tighten the
standoff into the desired nut location on the motherboard.
A
A
B
C
2
3
B
C
6cm
8cm
Type2260
Type 2280
Type 22110
B
C
B
C
4. Gently insert the M.2 SSD module into the M.2 slot.
Please be aware that the M.2 SSD module only fits in one orientation.
5. Tighten the screw with a screwdriver to secure the module into place.
Please do not overtighten the screw as this might damage the module.
Ultra QUAD M.2 card Utility
D
With the ASRock Ultra QUAD M.2 card Utility, you can check that if your
M.2 SSD is properly installed and adjust the fan speed. Place the Support CD
4
into your DVD-ROM drive to run this utility or download it from the ASRock
D
website.
11cm
D
D
A
20
o
A
T 1
N U
T 2
N U
Select a fan speed mode
[Manual] Select a fan speed preference
[Disable] Turn off the fan
B
B
C
D
M.2 SSD
Status
Advertisement
