Panasonic KX-HNB600 User Manual page 112

Troubleshooting
Smart plugs stay on longer than they should be
R If you configure a smart control scenario to turn on a smart plug when triggered by a sensor, and if the
sensor is triggered multiple times, the smart plug may stay turned on longer than anticipated.
→This is not a malfunction. The smart plug stays turned on for the set amount of time each time the
sensor is triggered. If the sensor is triggered again before the previous "power on" time ends, the
smart plug may stay turned on longer than you anticipated.
In the example below, the system is configured to turn the smart plug on for 10 minutes when the
motion sensor is triggered. The sensor was triggered at 12:00 and the system turned the smart plug
on for 10 minutes. When the sensor was triggered again at 12:05, the smart plug was already on, so
the system waited until 12:15 (10 minutes after the last trigger) to turn off the smart plug.
The smart plug remained on for 15 minutes.
12:00
Sensor was triggered
Smart plug on
Refer to the following after checking the general troubleshooting information described in "General
information", Page 105.
[Device is in use.] is displayed
R Another user (i.e., mobile device) is already accessing the hub, the same screen, or the same feature.
→Wait for the other user to finish and then try again.
[The hub's SD card is full.] is displayed
R The SD card is full.
→Erase unnecessary images from the SD card. If you saved other data on the SD card using another
device, use the other device and erase any unnecessary data.
→Turn on the recording overwrite feature ( "General camera settings", Page 63) so that new
recordings automatically erase old ones.
[There is no SD card in the hub.] is displayed
R There is no SD card inserted in the hub.
→Insert a compatible SD card.
[Communication error] is displayed
R Your mobile device could not communicate with the hub.
→Check all connections and settings and try again.
[Out of Range] is displayed
R The hub could not communicate with the camera.
→Check all connections and settings and try again.
→Move the camera closer to the hub or, if possible, remove any obstacles between the camera and
the hub.
[Hub SD card error.] is displayed
R The SD card is not formatted for use with the hub.
112
12:05 12:10 12:15