Audio Connections; Attaching The Small Ferrite Cores To Audio Cables; Connecting Audio Inputs - Runco CinemaWall SP-42xa Owner's Operating Manual

Attaching the Ferrite Cores to the Audio Cables: Three (3), small ferrite cores are
provided with the CinemaWall. Before connecting your audio equipment, attach a ferrite
core to each audio cable as shown in Figure 3-9. Doing so will reduce radio frequency
interference (RFI) emissions to a level that conforms to FCC regulations.
Wind the audio cable around the ferrite core once, then fasten the catch. If you are using
all five audio inputs and/or the audio output (see Figure 3-11), obtain and install additional
ferrite cores as needed.
Small Ferrite Core
Figure 3-9. Attaching the Small Ferrite Cores to Audio Cables
Audio Inputs: The CinemaWall has five (5), stereo audio inputs; each one corresponds to
a video input.
Connect the audio outputs from your source components to these inputs using a cable
with a stereo miniplug at the CinemaWall end and the appropriate connector(s) (stereo
miniplug or dual RCA plugs) at the other end; see Figure 3-10.
INPUT 1 / INPUT 2
OUTPUT INPUT1 INPUT2
AUDIO AUDIO AUDIO
INPUT 5 / INPUT 4 / INPUT 3
COMPONENT
Figure 3-10. Connecting Audio Inputs
Runco CinemaWall SP Series Owner's Operating Manual
Audio Cable (not supplied)
23
Installation

Audio Connections