Interface - Runco CinemaWall CW-43MC Owner's Operating Manual

RS-232C ADJUSTMENT MODE

Interface

1) Connector: D-sub 9 pins (male)
2) Pin Layout:
3) Baud Rate: 9600 bps (standard)
(switchable to 1200, 2400, 4800, 19200, 38400 bps)
NOTE: The baud rate of this display should be set to match the baud rate of the computer. Also, when the
RS-232C cable is to be extended over a long distance, a slower baud rate is recommended.
4) Data Format
Start: 1-bit
Data: 8-bit
Parity: 0 (no parity)
Stop: 1-bit
5) Connection
Control PC
(with D25 serial port )
GND 7
* D-sub 9-pin/D-sub 25-pin conversion tables are now available on the market
NOTE: Computer manufacturers may not use the same pin assignments. In case of communication difficulties,
check pin functions not just pin numbers.
Pin No. Signal
1 NC (not connected)
2 TxD (Transmit Data)
3 RxD (Receive Data)
4 NC (not connected)
5 GnD
6 NC (not connected)
7 NC (not connected)
8 RTS (Request to Send)
9 NC (not connected)
RXD 3
TXD 2
CTS 5
Plasma Display
(CW-43/50MC)
2 TXD
3 RXD
8 RTS
5 GND
20
1 5
6 9
Control PC
(with D9 serial port)
RXD 2
TXD 3
CTS 8
GND 5
Straight Cable
.
Plasma Display
(CW-43/50MC)
2 TXD
3 RXD
8 RTS
5 GND