Advertisement
Table of Contents
- 1 Table of Contents
- 2 Freight Claim Procedure
- 3 Model Number and Serial Number Format
- 4 Installation Guidelines
- 5 Remote Condenser Guidelines
- 6 Electrical and Plumbing Requirements
- 7 How the Machine Works
- 8 Start-Up Procedure
- 9 General Maintenance
- 10 Cleaning Procedure
- 11 Cabinet Care
- 12 Winterizing Procedure
- 13 Maintenance Record
- Download this manual
Installation, Start-Up and Maintenance Manual
ICE SERIES CUBERS
ICE0250 through ICE2100 Series*
ICEU150, ICEU220 and ICEU300 Undercounter Series*
ICE0320, ICE0520, ICE0726, ICE0926 22 Inch Series*
*INCLUDES 230/50/1 VOLT UNITS
Ice-O-Matic
11100 East 45th Ave
Denver, Colorado 80239
Part Number 9081264-01 Rev. P
Print Date 11/22/16
Advertisement
Table of Contents
Related Manuals for Ice-O-Matic ICE2107R
Summary of Contents for Ice-O-Matic ICE2107R
- Page 1 ICE SERIES CUBERS ICE0250 through ICE2100 Series* ICEU150, ICEU220 and ICEU300 Undercounter Series* ICE0320, ICE0520, ICE0726, ICE0926 22 Inch Series* *INCLUDES 230/50/1 VOLT UNITS Ice-O-Matic 11100 East 45th Ave Denver, Colorado 80239 Part Number 9081264-01 Rev. P Print Date 11/22/16...
- Page 2 Ice-O-Matic Warranty Every Ice-O-Matic ice maker is backed by a warranty that provides both parts and labor coverage. To view the warranty details, register products, or check your warranty status visit the “Warranty and Water Filter Registration”...
-
Page 3: Table Of Contents
ICE Series Table of Contents Introduction Page i Warranty Page i Table of Contents Page ii Freight Claim Procedure Page iii Model Number and Serial Number Format Page 1 Installation Guidelines Page 2 Remote Condenser Guidelines Page 4 Electrical and Plumbing Requirements Page 6 How the Machine Works Page 15... -
Page 4: Freight Claim Procedure
If loss or damage does not appear until merchandise has been unpacked, make a written request for inspection by the carrier within 15 days of the delivery date. Then file a claim on a form from the carrier. File Claim Without Delay Do Not Return Damaged Merchandise to Ice-O-Matic Page iii... -
Page 5: Model Number And Serial Number Format
Series: Environmental Cuber (Uses HFC Refrigerant) This format is 14 characters long and begins with a date code followed by the Ice-O-Matic identifier, and then a sequential number. This is an entirely numerical serial number. The serial number will look like the example. -
Page 6: Installation Guidelines
Installation Guidelines Installation Guidelines For proper operation of the Ice-O-Matic ice machine, the following installation guidelines must be followed. Failure to do so may result in loss of production capacity, premature part failures, and may void all warranties. Reference the installation parameters prior to installing the machine: Ambient Operating Temperatures Minimum Operating Temperature: 50°F (10°C) - Page 7 If the ice machine is too far forward on the bin, the opened door may not be stable, resulting in an unexpected closing of the bin door. If the ice machine is to be mounted on a bin or dispenser other than an Ice-O-Matic, refer to the manufacturers instructions for machine mounting.
-
Page 8: Remote Condenser Guidelines
Remote Condenser Guidelines Remote Condenser Installation For proper operation of the Ice-O-Matic ice machine, the following installation guidelines must be followed. Failure to do so may result in loss of production capacity, premature part failure, and may void all warranties. - Page 9 Mixing Valve (Head Master). Only one valve is required per system. Kits are available to modify the condenser for compatibility. For more information contact your Ice-O-Matic Distributor. 34 ft. horizontal 10 ft. drop 10 ft.
-
Page 10: Electrical And Plumbing Requirements
ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICEU150, 220, 225 and 226 Note: The ICEU150, 220, 225 and 226 do not have a splash curtain. These models utilize a thermostatic bin control in place of a mechanical bin switch. - Page 11 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICEU300 and 305 Note: The ICEU300 and ICEU305 do not have a splash curtain. These models utilize a thermostatic bin control in place of a mechanical bin switch. ON-OFF-WASH Switch is located in the control box.
- Page 12 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0250, ICE0305, ICE0400/5/6, ICE0500 and ICE0605/6 Page 8...
- Page 13 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0805/6, ICE855/6GA and ICE1005/6/7 Page 9...
- Page 14 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE1405/6/7, ICE1806/7 and ICE2106/7 Page 10...
- Page 15 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0320/5 and ICE0520/5 Page 11...
- Page 16 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE1506R5 Remote Page 12...
- Page 17 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE1506HT Air Cooled, Top Air Discharge Clearance Requirements for the ICE1506HT to insure proper air circulation. 8 inches Back 6 inches Sides 2 inches Page 13...
- Page 18 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0726 and ICE0926 Remote Page 14...
-
Page 19: How The Machine Works
ICE Series How the ICE Machine Works How the ICE Machine Works A general description of how the ICE Series cubers works is given below. With the ICE/OFF/WASH switch in the ICE position, the compressor, water pump and condenser fan motor (when applicable) will energize starting the freeze cycle. -
Page 20: Start-Up Procedure
ICE Series Start-Up Procedure Start-Up Procedure Before starting the machine, make sure the machine is level within 1/8 inch in all directions, the bin or dispenser leg height can be adjusted by rotating the leg foot. Check the water level in the water trough. It should be approximately ½ inch above the top of the water pump impeller housing. - Page 21 ICE Series Start-Up Procedure Bin Control Operation The bin control is used to shut the machine off when the bin fills with ice. The bin control must be checked upon installation or initial start-up and when performing maintenance. Adjustments are not covered under warranty. There is one bin switch for each evaporator.
-
Page 22: General Maintenance
ICE Series General Maintenance Electrical shock and/or injury from moving parts inside this machine can cause serious injury. Disconnect electrical supply to machine prior to performing any adjustments or repairs. Failure to perform the required maintenance at the frequency specified will void warranty coverage in the event of a related failure. -
Page 23: Cleaning Procedure
Because the RO process removes all minerals and metals from the water it can promote the faster growth of microbial, mold and slime. If RO water is used, Ice-O-Matic recommends the water pH is verified to be a neutral 7.0 to minimize the corrosive effects. - Page 24 Citric Acid 3% to 7% Ice-O-Matic recommends cleaning be done by a trained technician and that they follow detailed steps as prescribed in the Technical Service Manual. Most cleaners list in their instructions an ounces to a gallon mixture for proper level of solution. Pouring undiluted cleaner directly into the water trough may not give proper dilution level.
-
Page 25: Cabinet Care
ICE Series Cabinet Care Cleaning Stainless Steel and Aluminum Commercial grades of stainless steel and aluminum are susceptible to rusting and corrosion if not properly maintained. It is important that you properly care for the stainless steel and aluminum surfaces of your ice machine and bin to avoid the possibility of rust or corrosion. -
Page 26: Winterizing Procedure
ICE Series Winterizing Procedure Winterizing Procedures Important! Whenever the ice machine is taken out of operation during the winter months, the procedure below must be performed. Failure to do so may cause serious damage and will void all warranties. 1. Turn off water to machine. 2. -
Page 27: Maintenance Record
ICE Series Service History Service History Model Number__________________Serial Number__________________Date Installed__________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________...