Configuration Display - DEC VAXstation 3100 Owner's Manual

The system displays the number of each device as it is tested,
followed by three periods (...)• If the self-test is successful, no
question mark or error message is displayed, and the console
prompt appears:
7. . .
» >
If the device is not installed, or is not tested, an underscore
and two dots ( ) is displayed before the console prompt
appears.
7_..
» >
If a device fails the self-test, a question mark (?) follows the
device identifier and a failure message is displayed before the
console prompt appears.
7?..
84 FAIL
» >
If a self-test results in a failure, enter the TEST 50 command
to display your system configuration (no need to press the halt
button).
Call yoiir Digital service representative.
7.3 Configuration Display
©
The configuration display is a table that lists the status of each
device installed in your system. The configuration table holds the
results of the self-test and power-up tests. It is updated each time
the self-test program is run.
To display your system configuration, perform the following steps:
1 Put the Model 48 in console mode by pressing the halt button
on the rear of the system.
Note See operating system documentation for shutdown procedures
before turning your system off. Also, you should not turn
off, halt, or restart the system without notifying work group
members.
2 Enter the following:
» > TEST 50 IReturn I
This procedure displays the system configuration, Ethernet
hardware ID, ROM revision levels, and status information.
Running Diagnostics 7-7