Using Rechargeable Batteries; Aaa Battery Installation And Replacement; Reset Initialization - Royal Linea Pen Based PDA User Manual

Using Rechargeable Batteries

Your Royal PDA unit without built-in modem can only use the Royal rechargeable battery pack that
is sold separately. This battery pack is a sealed, self-contained cartridge. This cartridge replaces
the AAA alkaline cartridge which is factory-installed in your PDA. To use the Royal rechargeable
battery pack, remove the AAA alkaline cartridge and replace it with the Royal rechargeable
cartridge.
Before using the rechargeable battery pack for the first time, you must fully charge the batteries.
Please see the instructions that come with the Royal rechargeable battery pack for charging
requirements.
Before using the rechargeable battery cartridge for the first time, you must charge it for 5 hours..
Note: The unit will not charge any other battery.

AAA Battery Installation And Replacement

To insure the maximum protection of data stored in the PDA, we recommend the following
procedure be followed when replacing the AAA batteries.
1. Turn the PDA off.
2. Plug in the AC adapter to maintain data during battery replacement.
3. Remove the battery cover, located on the back of the unit, by pressing the hinge down and
pulling the battery cover open.
3. Insert the two new AAA batteries, following the signs inside the battery cartridge compartment.
4. Carefully place the battery cover in its place and press the cover gently into its location until
cover is locked in position
Note: Always turn the PDA off before unplugging or plugging in the AC/DC adapter.
DO NOT APPLY UNNECCESARY FORCE WHEN REMOVING OR REPLACING THE BATTERY
COVER. THE COVER SHOULD EASILY FIT INTO ITS PLACE IN THE BACK OF THE UNIT.
Note: Do not try to operate or synchronize the PDA with a low battery; this data can be corrupted
or lost.
Note: Battery voltages are constantly monitored. A low battery warning message will show when
the power level gets too low. Replace
when this message is displayed.
The data that has been synchronized to the computer can be restored to the PDA by synchronizing
again. For detailed software use instructions, see the "Instruction Files" provided with the
synchronization software.

RESET INITIALIZATION

1. Insert the writing end of the stylus into the reset opening on the backside of the unit.
2. The PDA calibration screen is displayed.
the AAA batteries or recharge the rechargeable
5
batteries