1. Manuals
  2. Brands
  3. Rowenta Manuals
  4. Iron
  5. DZ5020
  6. User manual

Rowenta DZ5020 User Manual

Rowenta iron user manual
Hide thumbs Also See for DZ5020:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual
www.rowenta.com
mod. DZ5020
GB
D
F
I
SP
P
RF
GR
UA

Advertisement

Table of Contents
loading

Related Manuals for Rowenta DZ5020

Summary of Contents for Rowenta DZ5020

  • Page 1 DZ5020 www.rowenta.com...
  • Page 3 fig. 1 fig. 4 fig. 7 fig. 10 fig. 2 fig. 5 fig. 8 fig. 11 fig. 3 fig. 6 fig. 9 fig. 12...
  • Page 4 fig. 13 fig. 14 fig. 15 fig. 16 fig. 17 fig. 18 fig. 19 fig. 20...

  • Page 6: Safety Instructions

    DESCRIPTION Spray nozzle Filling inlet (with slide-button opening) Variable steam control Dry ironing Steam max. position Self Clean Autosteam Spray button Shot of steam button Cord SAFETY INSTRUCTIONS This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic Compatibility, Low Voltage, Environment).

  • Page 7: Before Use

    – the appliance is obviously leaking. In these cases the appliance should be returned to an approved Rowenta Customer Service Centre for repair. (See enclosed Service Centre addresses.) Repairs to electrical appliances may only be carried out by specialists. Improperly carried out repairs can cause serious danger to users.

  • Page 8: Using For The First Time

    (fig.5). Move the steam control to steam 1 minute. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down.

  • Page 9: Dry Ironing

    AUTO- OFF The automatic electronic cut-out* is active. IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric.

  • Page 10: Shot Of Steam

    - After 30 sec., if the iron is left standing on the soleplate or lying on its side . - After 8 mins., if the iron is left standing on its heel.

  • Page 11: After Use

    Fill the water tank with tap untreated water up to the max mark and heat the iron to the ••• temperature. Unplug the iron and hold it over a sink horizontally. Hold the steam control into the Self Clean position (fig.5) : steam will now begin to build up.

  • Page 12: Cleaning The Iron

    Move the steam control to Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down. When cool, the soleplate can be wiped with a damp cloth.
  • Page 13 Soleplate temperature too low . If you are unable to trace the cause of the fault, contact an official Rowenta Customer Service Centre. The addresses are shown in the enclosed service centre address list. Helplines listed at the front of this leaflet.
  • Page 14 1103899452...

Table of Contents