Samsung EJ-FT820 Quick Start Manual

QUICK
START
GUIDE
EJ-FT820
Printed in Korea
GH68-47410D Rev.1.0
B Type 03/2017
English
a
f
b
c
g
d
e
A
B
Copyright © 2017 Samsung Electronics
•
Please read this guide before using the device to ensure safe
and proper use.
•
Images may differ in appearance from the actual product.
Content is subject to change without prior notice. Visit
www.samsung.com to view device information, the latest guide,
and more.
•
The keyboard is optimized to connect with the SAMSUNG Galaxy
Tab S3 and may not be compatible with other devices. Before
connecting the keyboard with devices other than the SAMSUNG
Galaxy Tab S3, make sure they are compatible with the keyboard.
•
Your consumer rights are governed by the law of the country in
which you purchased the product. Please contact your service
provider for more information.
Package contents
Keyboard, S Pen holder, Quick start guide
Device layout
Stand S Pen holder slot
Rear camera hole Dock ports
Connection hole Keyboard
S Pen holder
Attaching the S Pen holder
You can insert the S Pen into the S Pen holder attached to the
S Pen holder slot.
Make sure that the S Pen holder is securely attached after
24 hours. Do not reuse the adhesive tape if it detaches
from the surface.
Connecting the keyboard
When you connect the keyboard to a tablet, you can enter
characters without pressing the tablet's screen. You can also use
the keyboard as a cradle for the tablet by using its stand.
1. Position the tablet's rear camera to insert it into the rear camera
hole and attach the tablet to the stand. ( )
2. Insert the tablet into the connection hole to meet the tablet's
connectors and the dock ports. ( )
Make sure not to disconnect the tablet and the keyboard
accidentally or drop them while moving.
Safety information
Read all safety information before using the device to ensure safe
and proper use. To view the full safety information, refer to the
Samsung website.
The device contains magnets. The American Heart Association
(US) and the Medicines and Healthcare Products Regulatory
Agency (UK) both warn that magnets can affect the operation
of implanted pacemakers, cardioverters, defibrillators, insulin
pumps or other electro medical devices (collectively, "Medical
Device") within the range of 15 cm (6 inches). If you are a user
of any of these Medical Devices, DO NOT USE THIS DEVICE
UNLESS YOU HAVE CONSULTED WITH YOUR PHYSICIAN
Use manufacturer-approved accessories and supplies
Do not touch the device with wet hands
Do not drop or cause an impact to the device
The device can be used in locations with an ambient
temperature of 0 °C to 35 °C. You can store the device at an
ambient temperature of -20 °C to 50 °C. Using or storing the
device outside of the recommended temperature ranges may
damage the device
Prevent the dock ports from contact with conductive
materials, such as liquids, dust, metal powders, and pencil
leads
Do not allow children or animals to chew or suck the device
Do not disassemble, modify, or repair your device
FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this
device that are not expressly approved by the manufacturer may
void the user's authority to operate the equipment.
Note : This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications,
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Modifications not expressly approved by the manufacturer could
void your authority to operate the equipment under FCC rules.
CAN ICES-3(B)/NMB-3(B)