Using The System (At The Master Station); Answering A Call; When Receiving A Single Call - Aiphone NIM-20B Operation Manual

USING THE SYSTEM (AT THE MASTER STATION)

Answering a call

When receiving a single call

■ Answering with handset
1 Pick up the handset and talk
with the caller.
Lights up
green.
Lights up red while
sending audio from
this station to other
stations.
*
Corridor light and indicators on
the equipment other than the
master station turn off at the start
of talking.
2
To end the communication,
hang up the handset.
The following operations can be performed.
■ Answering in Push-to-Talk
mode
1
Press
with the caller.
Station 6
Station 7
Station 8
Station 9
To speak
Press and hold
speaking.
To listen to the caller
Release
*
Corridor light and indicators on
the equipment other than the
master station turns off at the
start of talking.
2 To end the communication,
press
Station 6
Station 7
Station 8
Station 9
and begin talking
TALK
NIM system
Lights up green.
Lights up red.
while
TALK
Lights up red.
while listening.
TALK
Turns off.
OFF
.
NIM system
• The ringtone sounds.
• The call-in/talk indicator for the
calling station blinks red.
•
If a corridor light is installed at the
sub station, it also lights up.
• If the call extension speaker IER-
2 is installed, it sounds the same
ringtone as the master station.
■ Going to the calling
location directly
1 Go to the calling location and
press the reset button for the
calling station.
The call indicator on the calling
station and the corresponding
indicators on the master station
turn off.
*
When two or more call indicators
are lit on a corridor light,
pressing the reset button turns off
all the indicators.
NOTES:
Communication will end automatically
•
after 90 seconds.
• Confi rm the calling station before pressing
the reset button. The indicators on the
master station and corridor light will turn
off when the reset button is pressed.
OFF
Pressing while talking ends
•
the communication and turns off the
indicators. Be sure to confi rm the calling
OFF
station before pressing .
There is communication only if a sub
•
station or speaker/microphone is installed
in the calling location.
When a new call comes in during
•
communication, the call-in/talk indicator
for the corresponding station blinks red
and the ringtone sounds at a low volume.
When you pick up the handset while
•
communicating in Push-to-Talk mode, you
can continue communicating by using the
handset.
11