Software Configuration - TP-Link EAP225-Wall Quick Installation Manual

2. Slide the mounting bracket to detach it from the EAP.
3. Insert the enclosed screws and tighten them with a philips screwdriver
to secure the mounting bracket.
Note:
Do not over tighten the screws.
If the enclosed screws do not fit the junction box, use the screws attached to the
junction box instead.
When mounting the bracket to a standard US junction box, use the holes on the
top and bottom side.
4. Connect the Ethernet cable inside the junction box to an RJ45 plug. Then
connect the cable to the ETH0 (PoE IN) port. Position the Ethernet cable to
ensure it is not strained.
Note:
If the junction box does not have enough room to accommodate the EAP, replace an
open‑end junction box or a deeper one.
5. Attach the EAP to the mounting bracket by aligning the two mounting studs
on the mounting bracket with the large openning of the slots on the EAP.
Press and slide the EAP down until it locks into place.
Tip:
To remove the EAP from the mounting bracket, insert a metal stick into the hole
next to the LED button to release the Locking Tab. Slide the EAP upwards and
pull it out to detach it from the mounting bracket, as shown below.
4

Software Configuration

The EAP supports two configuring options:
To configure and manage mass EAPs via centralized controller software,
please refer to Option 1.
To configure a single EAP via a web browser directly, please refer to
Option 2.
Option 1: Via EAP Controller
Step 1: Installing EAP Controller
On the PC, download the EAP Controller installation file from
http://www.tp-link.com/en/download/EAP-Controller.html. Run the file and
follow the wizard to install the EAP Controller.
Step 2: Configuring EAP Controller
Launch the EAP Controller and follow the step-by-step instructions to
complete the Quick Setup. After the wizard is finished, a login screen will
appear.
Step 3: Logging in to EAP Controller
Enter the admin name and password you created and click Sign In. Then
you can further configure the EAP Controller.
For detailed configurations, please visit http://www.tp-link.com/support to
download the User Guide of EAP Controller in the download center.
Option 2: Via Web Browser
Step 1: Connecting to the EAP Device
Power on the EAP and connect wirelessly by using the default SSID
(format: TP-Link_2.4GHz/5GHz_XXXXXX) printed on the product label.
Step 2: Logging in to the EAP Device
Launch a web browser and enter http://tplinkeap.net in the address bar.
Use admin for both Username and Password to log in.
Step 3: Configuring the EAP Device
Set up a new Username and Password for secure management purpose.
Modify the wireless parameters and reconnect your wireless devices to
the new wireless network.
For detailed configurations, please visit http://www.tp-link.com/support to
download the User Guide of EAP in the download center.
For technical support, User Guide and other information, please
visit http://www.tp-link.com/support, or simply scan the QR code.
The products of TP-Link partly contain software code developed by third parties, including software
code subject to the GNU General Public License ("GPL"). As applicable, the terms of the GPL and
any information on obtaining access to the respective GPL Code used in TP-Link products are
available to you in GPL-Code-Centre under (http://www.tp-link.com/en/support/gpl/). The respective
programs are distributed WITHOUT ANY WARRANTY and are subject to the copyrights of one or
more authors. For details, see the GPL Code and other terms of the GPL.