NEC SL2100 Quick Install Manual page 28

Configure the SL2100
Tell the SL2100 system how many DID numbers you have. If you are not sure then select 200.
Click the Add Range button to create one or more incoming DDI ranges.
Note – You can use the Add Range button as many times as you wish to build your bespoke DDI routing.
Received digits – Enter the first number in the incoming DDI range that will
be received from the network provider.
Name – Enter the name of the DDI range, this will be used for all DDI's, you
can edit individual DDI's later
Target – Enter the first extension number that the range of DDI's will ring at.
Leave blank if you don't want the DDI to ring at an extension
Voice mail – Check the box if each DDI should route to voicemail (requires
the optional InMail card to be installed)
Count – Enter the total quantity of DDI numbers received from the network
provider. This is the quantity of DDI's that will be setup by PCPro
Trunk Group – leave this at 1 as this is the default group.
Add to night mode – Uncheck each of the eight modes that you want the
DDI to route. PCPro will only setup the DDI's for the unchecked modes.
Quick Install Guide – SL2100 with ISDN PRI Trunks rev 1.1
28