Samsung AQ17KS Service Manual page 10

3 Disassembly and Reassembly
7. When the hold-snap release, lift the Rear
Cover slightly to make sure it doesn't re-
engage while you release the snap on the
other side.
Figure 5
8. In a similar manner, Release the hold-snap on
the opposite side.
9. Pull the Rear Cover up off the monitor.
Figure 6
10. Using pinch-nose pliers or ling-nose pliers,
acrefully disconnect the Anode Cap from the
CRT.
Warning: Do not touch the Anode contact
on the CRT (High Voltage may
remain).
Note : If the hold-snap on the bottom of the
Front Cover is broken, secure the
cabinet by applying a 4x16 screw in
the extra holes on each side of the
cabinet.
3-2
Figure 7
Figure 8
3-1-2 Removing the CRT Socket PCB
1. Complete all previous steps.
2. Lift up the Video Spring and remove the CRT
Socket PCB from the CRT.
Figure 9
3. Disconnect all connectors on the CRT Socket
PCB.
4. Using a solder iron, disconnect Ground (G2)
on the back of the Video Shield and remove
the Shield Cap.
5. Remove the screw on the front of the Shield
Socket.
6. Desolder the 4 tabs on the CRT Socket PCB
and remove Shield.
7. Place the Video PCB on a flat, level surface
that is protected from static electricity.
AQ17KS