Table of Contents
Advertisement
1
The screw on the
™
lamp cover and the
lamp cannot be
removed.
The projector
™
cannot be turned
on if the lamp
cover has not been
placed back on the
projector.
Do not touch the
™
glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the " " button on Keypad of
the projector or on the remote control.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Unscrew the one screw on the cover. 1
5. Push up and remove the cover. 2
6. Lift up the lamp handle. 3
7. Press on the both sides then lift up and remove the lamp cord. 4
8. Unscrew the one screw on the lamp module. 5
9. Lift up the lamp handle 6 and remove the lamp module slowly and carefully. 7
To replace the lamp module, reverse the previous steps.
10.
Turn on the projector and reset the lamp timer.
Lamp Reset: (i) Press "Menu" (ii) Select "Options" (iii) Select
2
3
"Lamp Settings" (iv) Select "Lamp Reset" (v) Select "Yes".
Appendices
5
4
5
6
7
57
English
Hide quick links:
Advertisement
Table of Contents
