Toto WASHLET TCF6532G Instruction Manual page 4

Safety Precautions
To reduce the danger of burns, death from electric shock, fi re or other
human injury:
  Never operate this product if it has a damaged cord or plug, if it is not working properly, if it
has been dropped or damaged, or if it has been dropped in water. Return the product to TOTO
Europe GmbH for examination and repair.
  Never block the air openings of the product or place it on a soft surface, such as a bed or a
couch, where the air openings could be blocked. Keep the air openings free of lint, hair or a
similar material.
  Never use it while sleepy or drowsy.
  Never drop or insert anything into any opening or hose.
  Do not use it outdoors where aerosol (spray) products are being used or where oxygen is
being administered.
Do not stick a fi nger or anything else into the warm air outlet.
Do not place anything on the warm air outlet or drape clothes over it.
  Doing so may cause burns, electrical shock or malfunction.
Keep cigarettes and other open fl ames away from the product.
  Failure to do so may cause fi re.
Beware of irritation or burn
  Improper use of the toilet seat may cause irritation or burn.
When sitting for a long time on the toilet seat, switch the toilet seat temperature adjustment to "OFF".
When any of the following persons use a heated seat or warm air drying, someone should switch
the toilet seat temperature adjustment to "OFF" and switch the drying air temperature to "Low".
  Young children, the aged and other users unable to set the temperature appropriately themselves
  The ill, physically disabled and others who do not have freedom of movement.
  Those using any medicines that cause drowsiness (sleeping or cold medicine), those who have
been drinking heavily, anyone severely fatigued and anyone else liable to fall asleep.
To reduce the danger of burns, death from electric shock, fi re or other
human injury:
  Close supervision is necessary when this product is used by or near children or invalids.
  Use this product only for its intended use as described in this manual. Do not use accessories
not recommended by the manufacturer.
  Keep the cord away from heated surfaces.
  Connect this product to a properly grounded outlet only.
 
The tank should only be fi lled with water.
6
(Continued)
WARNING WARNING
This is an electrical product. Do not install it anywhere water is likely to
get on the product or anywhere with humidity high enough that water is
likely to form on the surface of this product. When using the product in a
bathroom, install a fan or ventilation port and ensure good air fl ow through
the bathroom.
  Failure to do so may cause fi re or electrical shock.
Always connect the Washlet to the cold water supply.
  Connecting to hot water supply may result in burns and equipment damage.
Check that an appropriate ground is installed.
 
If the ground is not installed, if there is a breakdown or electrical current leak, the lack of a
ground could cause electrical shock.
For the ground, use copper wire with a ground resistance of 100 Ω max. and a diameter of 1.6 mm min.
* If there is no ground installed, ask the contractor who did the installation to install the ground.
Make sure that a properly grounded (3 prong) outlet has been installed.
  Failure to install a grounded outlet could cause electrical shock in the event of a malfunction or
short circuit.
Check that the outlet for electrical power is as follows.
  Failure to do so may cause fi re or electrical shock.
a. Apply a current to the outlet (or device) through a differential residual current device whose
release current does not exceed 30 mA.
b. Install the outlet (or device) and its wiring plug at least 0.60 m away from the outside of the
shower tub or bathtub.
* Check that the wiring in a. and b. above is complete. If the wiring has not been completed, ask
the contractor who did the installation to do it.
Insert the power plug securely into the outlet.
Check that the power cord is connected.
(Electrical box type, Concealed power connection type)
  Failure to do so may cause fi re, heat or short circuit.
* When installing this product, observe the local laws and regulations regarding installation.
To unplug, hold the plug, not the cord.
(Except electrical box type, Concealed power connection type)
Do not unplug by pulling the cord.
  Pulling on the cord may cause damage and result in fi re or heat.
If the electric cord is damaged, avoid danger by having the manufacturer's
repair department or equivalent specialist replace it.
7