Russound Decora 858 Instruction Manual

858
Decora ®
Infrared Receiver
Instruction Manual
STATUS INDICATOR
To use the status indicator on the 858 connect the 12 Volt 100mA or higher
power supply to the STATUS line of the 857 connecting block as shown in
Figure 2. Plug the power supply into the switched outlet on the stereo
receiver. When the receiver is on, the power supply will turn on the system
status line and illuminate the LED Green of the 858. The status line can be
turned on or off by setting the jumper on back of the 858 as shown in
Figure 3.
12 VDC
Figure 2
STATUS ON
ST IR GND V+
Figure 3
Style In-Wall
IR RECEIVER
S
TATUS
+12VDC
P
OWER
+12VDC
IR R I
ECEIVER N
IR C I
OMMON N
+
12VDC
GND
STATUS
SIGNAL
DESIGNED IN USA MADE IN CHINA
857
CONNECTING
BLOCK
STATUS OFF
ST IR GND V+
PRODUCT OVERVIEW
The 858 IR Receiver receives IR signals from a handheld IR remote control
and relays this to the audio/video equipment for operation from another
room. Mounts to a single gang J-Box using a Decora
FEATURES
®
• Stylish Decora design
• Dual color LED - green for system status and blue for talk back
• Ultra thin design - mounts easily in any J-box or P-ring
• Wide band IR - receives IR from many types of remote controls
INSTALLATION
Connect the 858 to the 857 (or equivalent) connecting block using 2 twisted
pair wire. Use one pair to connect GND (GROUND) and IR (SIGNAL). Use the
other pair to connect ST (STATUS) and V+ (+12VDC). If the wire has a shield,
connect it to the ground at both ends. See Figure 1 for detail of these
connections.
CONNECT TO
846C POWER
SUPPLY
SHIELD WIRED
TO GROUND
ST IR GND V+
2-TWISTED
Figure 1
PAIR WIRE
MOUNTING
Mount the 858 to the J-Box using the screws that are supplied. Mount the
cover plate (not included) to the IR receiver. See Figure 4.
Figure 4
®
cover plate.
12 VDC
S
TATUS
+12VDC
P
OWER
+12VDC
IR R I
ECEIVER N
IR C I
OMMON N
+
12VDC
GND
STATUS
SIGNAL
DESIGNED IN USA MADE IN CHINA
857
CONNECTING
BLOCK