Setting The Temperature; Enabling Wifi Signal For Optional App - Dometic CFX100W Operating Manual

Operation
7.6

Setting the temperature

➤ Press the "SET" button (fig. 3 4, page 3) once.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN –" (fig. 3 6, page 3) buttons to
select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
I
NOTE
The temperature of each compartment can be set to –22 °C. The
manufacturer however recommends a cooling temperature of –15 °C to
–18 °C for normal usage and optimum energy consumption.
7.7

Enabling WiFi signal for optional app

The cooler can be controlled via WiFi using an app that you can install on a
compatible device. The app has control, display and alarm functions.
For further information go to the Dometic website for your country (see back page).
Note that the app may not be available in your country.
The WiFi name of the compressor cooler begins with "CFX". The preset password is
"00000000". You can change the WiFi name and password individually.
Switching the WiFi signal on or off
➤ Press the "SET" button (fig. 3 4, page 3) five times.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN–" (fig. 3 6, page 3) buttons to
switch the WiFi signal on or off.
✓ The desired setting appears in the display for a few seconds. The display flashes
several times and then the current temperature is displayed again.
I
NOTE
• The default setting for the WiFi transmitter is off. For first time use and
whenever power to the device is interrupted, switch on the WiFi
transmitter to use the app.
• The WiFi transmitter uses a small amount of power. For optimal
energy performance switch the WiFi transmitter off if it is not being
used.
24
CFX100W
EN