Assembly - Husqvarna 545RXT AutoTune Operator's Manual

• Let an approved Husqvarna service agent do
servicing on the product regularly.
Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.
To attach the throttle handle
Note: On 545FXT AT the throttle handle is attached at
the factory.
1. Remove the nut and screw at the bottom of the
throttle handle.
2. Put the throttle handle onto the right side of the
handlebar.
3. Align the screw hole in the throttle handle with the
hole in the handlebar.
4. Put the screw into the hole at the bottom of the
throttle handle, through the handlebar.
5. Put back and tighten the nut.
10
• Replace damaged, worn or broken parts.

Assembly

To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a comfortable
work position.
5. Tighten the knob fully.
To put the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
is against the engine.
3. Turn the handlebar around the shaft.
171 - 001 - 20.10.2017