Roland VXpanded VS-880 Owner's Manual page 103

EFFECT1 (Effect 1 switch)
Select how the signal will be sent to the EFFECT1 buss.
Off: The signal will not be sent.
PreFade: The signal from before the channel fader will be sent.
PstFade: The signal that passed through the channel fader will be sent.
Insert: Insert between the equalizer and fader.
InsertL: Insert into the L side of a stereo effect.
InsertR: Insert into the R side of a stereo effect.
InsertS: Insert the L side and R side of a stereo effect in series.
* If the effect is inserted in another channel, the value will appear as ÒÑÐ,Ó and cannot be selected.
9. Press PARAMETER [
The display will indicate ÒEFFECT1 Send=Ó.
10. Adjust the send level to effect 1. Rotate the TIME/VALUE dial.
EFFECT 1 Send (Effect 1 send level)
Specify the volume level (0Ð127) of the signal that is sent to the EFFECT 1 buss. The default setting
is 100.
11. Press PARAMETER [
The display will indicate ÒEFFECT1 Pan=Ó.
12. Adjust the pan of the signal being input to effect 1. Rotate the TIME/VALUE dial.
EFFECT 1 Pan (Effect 1 pan)
For channels on which Channel Link is ÒOff,Ó this sets the panning (L63Ð0ÐR63) of the stereo signal
which is output to the EFFECT 1 buss. ÒL63Ó is far left, and ÒR63Ó is far right.
For channels on which Channel Link is ÒOn,Ó this sets the left/right volume balance (L63Ð0ÐR63)
of the stereo signal from the paired channels which is output to the EFFECT 1 buss.
The default value is Ò0Ó (center).
13. Switch the mixer mode to TRACK MIX. Press [SELECT].
14. Use PARAMETER [
15. Rotate the TIME/VALUE dial. For this example, select "PstFade" so that the channel faders will
adjust the recording level.
BUSS Sw (buss switch)
This selects the way in which the signal is sent to the buss selected by Buss Select. If ÒOffÓ is select-
ed, the BUSS Sel, BUSS Level, and BUSS Pan/BUSS Bal parameters will not be available.
Off: not sent.
PreFade: The signal before passing through the channel fader will be sent to the buss.
PstFade: The signal after passing through the channel fader will be sent to the buss.
16. Press PARAMETER [
The display will indicate ÒTR1 BUSS SelÓ.
17. Rotate the TIME/VALUE dial. For this example, select "MIX" so that the signal will be sent from
master out.
BUSS Sel (buss select)
This selects the output destination buss (MIX, 1-2, 3-4, 5-6, 7-8). The numerals of the value indicate
the REC buss numbers.
TRACK MIX mode
CONDITION MARKER# TIME TIME
INPUT TRACK
].
].
][ ] to make the display read "TR1 BUSS Sw=".
].
dB
0
4
1 1 2 2
24
48
AUX MASTER
Chapter 8 Using the internal effects
103