Functions For Group Control & Multiple Remote Control - Sanyo SPW-CR1503GDYH8 Technical Data & Service Manual

1. Main Operating Functions
1-4. Functions for group control & multiple remote control
Group control and multiple remote control become possible by using remote controllers; however part of the functions of
the main and sub remote controller cannot be controlled. So, confirm them referring to the following table.
Diagram of system
outline
Remote control
functions
ON / OFF
Operation Mode switch
Temp setting
Fan speed setting
(H / Me / L / auto)
3
timer
72 hr ON / OFF
Arbitrary airflow
direction setting
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Sweep
Sensor temp. display
Service check
NOTE
To use as a sub unit (sub remote controller), the remote control address switch of its remote control PCB must be set
ON.
*1 In ECO & W-ECO multi system, first pressed cooling (dry) or heating mode has priority, different mode can not be
sellected later except fan mode.
If you select a different mode later, the indication "MODE FIXED" will be displayed on remote controller.
Individual remote control (standard)
Outdoor
Indoor
Main
637_8132
Each remote controller
Control of W-ECO MULTI SYSTEM
Group control
Outdoor
Indoor
Main Sub
638_8132
Main remote Sub remote
controller controller
(Collective, later pressed priority)
(Collective, first pressed priority *1)
(Collective, later pressed priority)
(Collective, later pressed priority)
(Timer setting with sub impossible) (Timer setting with sub impossible)
(Individual, later pressed priority)
(Individual, later pressed priority)
III - 4
Multiple remote control
Outdoor
Indoor
Main Main Sub
639_8132
Main remote Sub remote
controller controller
(Later pressed priority)
(First pressed priority *1)
(Later pressed priority)
(Later pressed priority)
(Later pressed priority)
(Later pressed priority)
TD831077