Attaching The Pad To A Stand; Connecting To A Percussion Sound Module - Roland PD-85 Owner's Manual

Attaching the Pad to a Stand

Attach the PD-85 to a stand (MDS series).
fig.Stand.e
Tighten
Loosen
Rod
Pass the rod through the pipe
that is inside the holder.
When attaching the PD-85 to a tom stand, check the
dimensions of the rod. Depending on the dimensions of
the rod, it may not be possible to attach the pad to the
stand.
Acceptable rod diameters:
8.5–11.5 mm (3/8 to 1/2 inch)
Connecting To A Percussion
Sound Module
Connecting to a percussion sound module (TD-20, TD-12, TD-
10, TD-8, TD-6V/6, TD-3, etc.).
When you have finished connecting to your percussion sound
module, refer to the owner's manual supplied with the sound
module, and make the settings for it.
• To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
• Use the included stereo cable to make connections.
Otherwise (if you use a monaural cable), you won't be
able to employ rim shot and cross stick playing
techniques.
• Connect the L-shaped plug of the included cable to the
PD-85. This will prevent strain from being applied to the
PD-85.
Percussion
Sound Module
TD-20
TD-12
TD-10
TD-8
TD-6V/6
TD-3
3
Rim Shot Capable
Trigger Inputs
2 (SNARE), 3–6 (TOM 1–4),
12–15 (AUX 1–4)
2 (SNARE), 3–5 (TOM 1–3),
11 (AUX 1), 12 (AUX 2)
2 (SNARE)
3 (SNARE)
2 (SNARE)
SNARE
Next