Table of Contents
Advertisement
Changing Various Settings
Switching VIMA CD-ROM
Recommended Tones
Songs on VIMA CD-ROMs (VIMA TUNES) are programmed
with "recommended tones" suitable for each song.
When you select a song, the recommended tones are
assigned to the RG-1's Tone buttons, and those Tone buttons
then flash.
When you press a flashing Tone button, the recommended
tone is then selected, enabling you to perform the selected
song using a tone matched to that song as it plays back.
You can set the RG-1 so that the recommended tones are
automatically assigned (On) or not assigned (Off).
→ You can use the Memory Backup function to store these
settings to the RG-1 (p. 71).
1.
Press the [Function] (Exit) button, getting its
indicator to light.
2.
Press the [Song] (Select -) button or [
+) button to select "Recommended Tone" in the
MISC screen.
fig.06-141d
3.
Press the [
] (Value -) button or [
+) button to switch the recommended tone setting
on or off.
Value
Description
The recommended tones are automatically
On
assigned to the RG-1's Tone buttons.
The recommended tones are not used, and
Off
only the RG-1's internal tones can be select-
ed.
This is set to "On" when shipped from the factory.
4.
Press the [Function] (Exit) button so the indicator
goes out.
76
Initializing the User Memory, USB
Memory, and Floppy Disks
You can delete all of the data in the User memory, in USB
memory, or on floppy disks and restore (initialize) the data
to the original default factory settings.
The RG-1 contains an internal memory area to which you can
save recorded performances and other data.
This area is called the "User Memory."
The content registered in the "Favorites" is stored in the User
Memory.
* Executing this procedure does not initialize any settings other
than the content of the User Memory. To restore the factory
defaults for settings other than the User Memory content,
carry out Factory Reset (p. 77).
1.
To initialize your USB memory, first connect the
USB memory to the External memory connector.
If you want to initialize a floppy disk, insert the
] (Select
floppy disk in the floppy disk drive.
2.
Press the [Function] (Exit) button, getting its
indicator to light.
3.
Press the [Song] (Select -) button or [
+) button to display the FILE screen.
] (Value
4.
Press the [Song] (Select -) button or [
+) button so "FORMAT" is flashing.
fig.06-150d
5.
Press the [Enter] button.
6.
Press the [
+) button to select the memory to be initialized.
fig.06-151d
] (Value -) button or [
] (Select
] (Select
] (Value
Advertisement
Table of Contents
