Spinsense (To Resolve Vibration Issues) - LG WM2496*M Series Training Manual

SPINSENSE
SpinSense is a software adjustment that allows a small adjustment in the spin
speeds to eliminate excessive vibration, particularly vibration caused when the
selected spin speed strikes a harmonic value in the floor and causes resonance.
To adjust the spin speeds to eliminate this issue, apply SpinSense using the
following steps. Also refer to the QC Test Mode on page 22 and
Troubleshooting Noise and Vibration on page 28 of this manual. Be sure the
washer is correctly installed and leveled.
1. The washer must be running (in any cycle) to operate the SpinSense
control. It must be past the load-sensing portion of the program.
2. The selected spin speed will have an LED lit in the button.
3. Press and hold the SpinSense button for over three seconds. (It is the
Stain Cycle button on the right end of the control panel.) You will hear two
quick beeps when the button is pressed and a long beep when the control
takes effect.
4. The spin button of the selected cycle will blink if SpinSense is turned on. If
the spin speed button is not blinking, SpinSense is turned off.
5. Turning SpinSense on affects all spin speeds for all cycles.
The SpinSense control is a non-volatile toggle. If you turn it ON or OFF, it will
remain in that state until it is changed by following the steps above. Activating
SpinSense should resolve 95% of all vibration issues. It will NOT solve the
problem of a shaky, loose, or poorly constructed floor.
WM2496H*M Page 29 of 58 TRAINING MANUAL