Advertisement
5. Connecting the Antennas and
Powering It Up
Step 1: You can directly connect the antenna to the AP if the antenna's
connector is N-Type (M). If not, please connect the N-Type
(M) RF cables to N-Type (F) antenna connectors of the
WDAP-8350, and connect the other end of the RF cables to the
N-Type (F) antennas.
N-Type (Male) to
N-Type (Male) RF cable
2.4GHz Antenna with
N-Type (M) connector
Step 2: Plug the RJ45 Ethernet cable into the PoE port of the WDAP-8350
through the waterproof kit, and plug the other side of the RJ45
cable into the PoE port of the PoE switch to finish the installation.
Waterproof Kit
Data
Default IP Address: 192.168.1.10
Default User Name: admin
Default Password: admin
Default 2.4GHz SSID: PLANET_AP_2G
Default 5GHz SSID: PLANET_AP_5G
Step 1: The Web management allows you to access and manage the
wireless AP easily. Launch the Web browser and enter the default
IP address http://192.168.1.10.
Step 2: When the login window appears, please enter the User Name and
the Password. The default User Name and Password are both
"admin". Then click the Login button to continue.
For security reasons, it is recommended to change the password at the
first login and memorize it.
※ The actual antenna
connection depends
on the antenna type
you choose. The
antennas are
required and must
be purchased
separately.
5GHz Antenna with
N-Type (F) connector
※ Please remember to
install the ground
cables onto the
ground terminal and
ground lugs.
802.3at PoE Switch
+
Power
– 5 –
– 7 –
6. Web Login
Connect the WDAP-8350 with your PC via an Ethernet cable plugged into
LAN port of PoE switch on one end and into LAN port of PC on the other
end. Power on the WDAP-8350 via PoE from PoE switch.
1. Click the "Start" button located in the lower-left corner of your
computer.
2. Click "Control Panel".
3. Double-click the "Network and Sharing Center" icon.
4. Click "Change Adapter Settings".
5. Double-click "Local Area Connection".
6. Select "Internet Protocol Version 4 (TCP/IPv4)" and click
"Properties".
7. Select "Use the following IP address" and then click the "OK"
button twice to save the configuration. For example, you may choose
from 192.168.1.1 to 192.168.1.254 excluding the default IP address of
the WDAP-8350 (192.168.1.10).
Step 3: After you enter into the Web User Interface, click Wireless
Settings at the left hand side of the screen to configure the
wireless connection. Once the basic configuration of the AP is
done. Click the Update button to make the change take effect.
FURTHER INFORMATION:
The above steps introduce the simple installations and configurations of the
WDAP-8350. For further configurations, please refer to the user manual, which
can be downloaded from the website.
http://www.planet.com.tw/en/support/download.php?type1=4&model=4875
9&type=3
If you have further questions, please contact the local dealer or distributor
where you purchased this product.
– 6 –
2011-E10630-000
– 8 –
Advertisement
