Specifications - Rockford Fosgate 250.1 Operation & Installation

250. S
1
P E C I F I C AT I O N S
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Mono into a 4 load
Mono into a 2 load
Bridged (using 2 Punch 250m) into a 4 load
Continuous Power Rating (Competition Standard) – Measured at 13.8 Volts
RMS continuous power mono, into a 4 load from 20-20,000Hz
with less than 0.10% THD
RMS continuous power mono, into a 2 load from 20-20,000Hz
with less than 0.15% THD
RMS continuous power bridged, (using 2 Punch 250.
Power amplifiers in the same system) into a 4 load
from 20-20,000Hz with less than 0.15% THD
Signal-to-Noise Ratio:
Frequency Response:
Bandwidth:
Damping Factor @ 4 (at output connector):
Slew Rate:
IM Distortion (IHF):
Input Impedance:
Input Sensitivity:
B+ Fuse Size: (External to amplifier)
Fuse Type:
Crossover Alignment:
Factory Crossover Frequency:
Factory Default Crossover Setting:
Dimensions:
1
Specifications subject to change without notice.
– 48 –
420 Watts
710 Watts
1420 Watts
250 Watts
500 Watts
1000 Watts
>100dB (A-weighted)
20Hz-20,000Hz 0.5dB
10Hz–250kHz 3dB
>200
50V s
<0.05%
20k Ohms
Variable from 300mV to 5V
Preset at the factory for 500mV
60 Amp or two 30 Amp
AGU / Maxi Fuse
12dB or 24dB/octave Butterworth
80Hz (0.047 f)
Full Range
9-5/8"W x 14-9/32"L x 2-5/8"H
(24.4cm) x (36.27cm) x (6.6cm)