Specifications - Rockford Fosgate Power T2500-1bd Installation And Operation Manual

S
PECIFICATIONS
MODEL- POWER
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Mono
2 Load Mono
1 Load Mono
Continuous Power Rating (RMS) - Two Amplifiers in bdSYNC Configuration
2 Load Bridged/Mono
Dimensions:
Battery Fuse Rating (Amp) External (Not Supplied)
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency (Low Pass Only)
Frequency Response
Signal Voltage Adjustment Range
Protection
Equalization PEQ (Punch Equalization)
Input Impedance
Infrasonic Filter
Operating Voltage
Balanced Inputs
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
These specifications are Amplifier Power Standard CEA-2006 Compliant
14
Height
Width
Length
Specifications subject to change without notice
T2500-1bd
1000 Watts x 1
1800 Watts x 1
2500 Watts x 1
5000 Watts x 1
2.14" (5.44cm)
8.14" (20.68cm)
21.875" (55.66cm)
24dB/octave Butterworth
variable from 35Hz to 250Hz
20Hz to 250Hz ±0.5dB
Variable from 150mV to 5V (RCA Input)
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in
case of overheating.
Variable from 0dB to +18dB @ 45Hz
20K ohms
Selectable 12dB/Octave, -3dB @ 28Hz
9 to 15.5 Volts DC
>55dB @ 1KHz
< 1% @ 1 ohm
300A
≥70 dB
≥100 dB
Yes
>200