Indicator Lamp - Makita HM1214C Instruction Manual

Number on adjusting dial
5
4
3
2
1
NOTE:
than those on load in order to reduce vibration
under no load, but this does not show trouble.
Once operation starts with a bit against con-
crete, blows per minute increase and get to the
the tool may not have this function even with the
motor rotating.
CAUTION:
far as 5 and back to 1. Do not force it past 5 or
work.

Indicator lamp

1.
indicator lamp (red)
The green power-ON indicator lamp lights up when the
tool is plugged. If the indicator lamp does not light up,
the mains cord or the controller may be malfunction.
The indicator lamp is lit but the tool does not start even
if the tool is switched on, the carbon brushes may be
switch may be malfunction.
carbon brushes are nearly worn out to indicate that the
motor will automatically be shut off.
ASSEMBLY
CAUTION:
unplugged before carrying out any work on the
tool.
Blows per minute
1,900
1,700
1,450
1,200
950
-
1
2
2. Service
5 ENGLISH
Side handle (auxiliary handle)
1
2
1. Side handle 2. Clamp nut
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal.
desired position. Then tighten the clamp nut securely.
Installing or removing the bit
1
1. Bit shank 2. Bit grease
Clean the bit shank and apply bit grease before install-
ing the bit.
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1. Releasing cover 2. Bit
releasing cover down a couple of times. Then insert the
bit again. Turn the bit and push it in until it engages.
2
1
2