Advertisement
What's in the box:
Send/end button
LED light
Rocketfish RF-GPS31126 Bluetooth headset (1)
Charger (1)
USB charging cable (1)
Round earbuds (4)
Ear loop (1)
Fitted earbuds
Quick Setup Guide (1)
(medium size is pre-attached) (3)
Charger
Headset
Ear bud
Charging port
with cover
Fitted earbuds
Round earbuds
Ear loop
2 Turn off your PS3 using the rear MAIN POWER switch, leave it off
1 Power & Pair
for about 10 seconds, then turn it back on. Press the front power
button. Find the Settings menu then press the (×) button on the
1 Lift the charging port cover, then connect the charger.
controller. Highlight the Register Bluetooth® Device icon, then
press (×). Highlight the Manage Bluetooth Devices icon, then
When the indicator changes from red to green, you can
Volume
disconnect the charger.
press (×). Select Yes to register a new device (if this is the first
touch pad
time registering a Bluetooth device), then highlight Start
Scanning and press (×).
LED light
What is PureSpeech®?
PureSpeech is a state-of-the-art noise cancelation and signal processing technology created by SRS Labs and CSR. Your RF-GPS31126
On/Off
headset incorporates PureSpeech so that you can hear your calls in amazing clarity, but also so you can be heard clearly by your callers.
(reverse side)
PureSpeech is always activated on the RF-GPS31126 so you will hear and be heard like never before.
3 Press and hold the headset' s power button for three seconds to turn
it on. It automatically enters pairing mode when you turn it on for
the first time. While in pairing mode, the headset' s LED flashes
green, and the PS3 finds and recognizes all Bluetooth devices
within its range. Your headset is recognized as RF-GPS31126.
4 When prompted for a pass key, enter "0000" (four zeros), then
highlight OK and press (×). The "Register completed" message
appears. You will then be taken to a new screen stating Register
completed. Press (O), highlight Audio Device Settings, then
press (×). Within Input Device, highlight RF-GPS31126, press
Bottom view
(×), then set your headset. Then set your microphone input
levels to the desired settings (we suggest level 3). The headset is
now connected.
To turn off the headset, press and hold the power button for
about two seconds.
To use a fitted earbud:
2 Get the perfect fit
1 Attach the appropriate size of fitted earbud
onto the headset. The medium fitted
Use one of the fitted earbuds for the most convenient and
earbud is already attached.
comfortable fit, or use a round earbud in combination with
2 Insert the headset vertically in your ear
the ear loop.
(shown in Step 2).
To use a rounded earbud:
3 Rotate the headset up towards your mouth.
1 Remove the fitted earbud that' s
The flexible portion of the earbud should fit
already attached, then press the
securely towards the back of your outer ear.
round earbud onto the headset.
You may need to guide it to a comfortable
2 Attach the ear loop for a secure fit.
position with your finger.
Advertisement
