Liebert DCD User Manual page 13

WARNING! Risk of heavy module falling. Can cause equipment damage, injury and death.
Two properly trained and qualified people are required to move and install the module. The
Liebert DCD weighs 210 lb. (95kg). Do not leave a Liebert DCD standing unattended on its side
or its end without adequate support to prevent it from falling over. The Liebert DCD must be
supported at all times or laid flat on protective material until it is installed.
CAUTION: Risk of sharp edges, splinters and exposed fasteners. Can cause injury.
Only properly trained personnel wearing appropriate safety headgear, gloves, shoes and
glasses should attempt to move, lift, remove packaging from or prepare the module for
installation.
NOTICE
Risk of a leaking coil due to freezing during improper storage. Can cause equipment and serious building
damage.
The heat exchanger and the supply pipes must be drained completely before the unit is stored.
Compressed air can be used to remove the water. Remove all the vents and the screws before storing.
NOTICE
Risk of improper storage. Can cause module damage and serious building damage.
Keep the module indoors and protected from dampness, freezing temperatures and contact damage.
NOTICE
Risk of damage from forklift. Can cause exterior and/or underside damage.
Keep the forklift's tines level and at a height suitable to fit below the skid.
Figure 2.3 Recommended module handling equipment
Vertiv | Liebert® DCD™ User Manual | 9