Belt Clip Installation - BellSouth GH9407 Owner's Manual

Getting Started
6. We recommend not placing this unit next to appliances. Doing so may cause interference.
7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the
BATTERY COMPARTMENT.
8. Place the BATTERY PACK inside the BATTERY COMPARTMENT.
9. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position.
10. IMPORTANT: Before initial use, charge the HANDSET for 12 hours.
7
11. TONE/PULSE Select Switch:
A. If your home is equipped with a tone dialing system, set the TONE/PULSE Select Switch to
the TONE position.
B. If you have a rotary dialing system, set the TONE/PULSE Select Switch to the PULSE
position.
C. If you are unsure which system you have, set the TONE/PULSE Select Switch to the TONE
position. Press the
on the TELEPHONE KEYPAD except the zero. If the dial tone continues, it means that you
do not have tone dialing service. Press the
the TONE/PULSE Select Switch to the PULSE mode and then try again.
Press the button to confirm that you have a dial
TALK
tone. If you do not get a dial tone, review steps 3
through 11. If you still do not have a dial tone, refer to
the Problem Solving section on page 13.

Belt Clip Installation

With the back of the HANDSET facing up, insert one
side of the BELT CLIP HOOK into the matching slot at
the top side of the HANDSET. Press down on the
opposite side of the BELT CLIP until the other hook
locks into the slot on the side of the HANDSET.
8
BATTERY PACK
button on the HANDSET to get a dial tone, and press any button
TALK
TALK
You are now ready to use your new
BellSouth Cordless Telephone.
5
BATTERY
COMPARTMENT
COVER
9
button on the HANDSET to hang up. Set
BELT CLIP HOOK